SETTING UP THE UNIT
WHERE TO USE THE UNIT
Keep at least 3.9 (10 cm) away from the wall.
Approx. 57.9 (147 cm)
Width
approx. 27.5 (70 cm)
Area where unit
touches the floor
1 UNPACK THE UNIT AND RAISE THE BACKREST
CAUTION
•
When raising the backrest, be careful not to cause hands or feet to become caught between the backrest and the
backrest latch or the backrest and the armrests.
Failure to follow this precaution may result in injury.
2 INSPECT CONTENTS OF SHIPPING CONTAINER
Massage Lounger
7
Approx.
11.8 (30 cm)
Mat
1
2
3
Backrest latch
Check that there
is nothing
around the unit.
Pillow
Back Cushion
Armrests — 2
•
Avoid places where the unit will be exposed to direct sunlight
for long periods of time or places where it will be exposed to
high temperatures, such as in front of a heater, etc., as this
can cause discoloration or hardening of the leather.
•
Placing a mat or cloth under the unit is recommended to
prevent floor damage. The size of the mat should be sufficient
[at least 4.1 in. × 7.5 in. (107 cm × 70 cm)] to cover the
areas where the unit touches.
•
Set the unit near the outlet.
See Warning No. 11 and 1 on page 1.
Remove the top of the shipping container.
•
When packed for shipping the backrest is folded forward.
Remove the packing and cushioning
materials and take out all accessories.
Raise the backrest.
•
Do not connect the power cord to an electrical outlet during setup.
•
Hold the backrest with both hands and lift in the direction of the
arrow until it comes to a stop.
•
Be careful the power cord and controller are not caught in the
backrest.
Allen Key — 1
Attachment Screws — 8
Lock Switch Key — 1
•
The lock switch key has
been inserted in the
lock switch prior to
leaving the factory.