Publicité
5 FIX THE CONTROLLER CORD
Approx. 0 (51 cm)
6 ATTACHING THE BACK CUSHION AND PILLOW
FOLDING THE BACKREST FORWARD (REPACKING)
CAUTION
•
Keep hands, feet, children, objects, etc., clear of openings on the unit, including seat and armrests; gaps between
the unit and the floor; and the backrest's range of movement when being folded forward.
Failure to do so could result in injury.
•
The unit should not be turned on and the controls should not be operated on when the backrest is folded forward.
Failure to follow these instructions could result in injury.
•
The unit should not be climbed on and objects should not be placed on the unit when the backrest is folded
forward.
Failure to follow these instructions could result in damage to the unit.
•
In the interests of safety, the backrest should always be folded forward by two persons.
1
Press the OFF/ON button to switch off the power.
2
Slide the power switch to the "off" position, lock it, and then unplug the power
cord.
3
Remove the back cushion and the pillow from the unit.
4
Remove the armrest from the unit.
Refer to "INSTALL THE ARMRESTS ON THE UNIT" on page 8 and remove them in
reverse order.
5
Insert a screwdriver into the opening for the backrest latch
approx. 1.6 in. (4 cm) from the upper edge of the opening
(until the screwdriver contacts the backrest latch).
6
Push tip of screwdriver downward approx. 1 in. (2.5 cm) to
release backrest latch.
7
Pull out screwdriver when pushing of backrest toward
seat begins.
*Be careful to avoid catching the controller or the cord between the backrest and the seat.
* I t is recommended that you move the unit before folding the backrest (upright
position). When the backrest is folded, it is not fixed and is unstable.
BEFORE USING THE UNIT
1 CHECK THE SURROUNDING AREA
9
Use the controller cord velcroes to secure the cord, leaving approximately 20 in.
(51 cm) of free wire.
* Confirm that there is a margin for the controller cord length when the backrest is reclined.
(The illustration shows that the cord is attached to the right armrest.)
1
Attach the back cushion using the zipper.
2
Attach the pillow using the velcroes.
Check that there is nothing around the
unit.
7
7
5
5
6
6
Publicité
