Publicité
1. INTRODUCTION
IMPORTANT! All local regulations, including those
that refer to national or European regulations, must
be applied when installing this device.
The way the stove is installed will decisively affect
safety issues and its correct operation.
It is important to install the stove correctly. For the
correct installation of the stove and chimney, we rec-
ommend the installation be performed by a profes-
sional.
Please read this entire manual before you install and
use your new room heater. Failure to follow instruc-
tions may result in property damage or bodily injury.
2. INSTALLATION
The appliance must be placed at least 40 cm (16'')
away from any combustible materials. lt may be
necessary to protect the wall and surrounding
materials. The appliance must be placed on a solid,
fire proof hearth conforming to the current
regulations.
Ensure that the chimney is free from soot and
debris and is as straight as possible.
The connection between the unit and the chimney
must be airtight and made with noncombustible
materials, protected against oxidation (enameled or
stainless steel flue pipe).
The chimney must be impermeable and its sides
not too rough.
The chimney will be sufficiently high and clear of
the house ridge by at least 1 meter to prevent any
down draught. It will be protected by insulating
material in order to reduce the risk of soot stains in
the top part of the flue and possibly be fitted with a
cowl to keep out the rain.
If the chimney is in poor condition or creates a poor
chimney draught, consider lining the flue. It is very im-
portant that the chimney does not create an excess
draught. Consider planning for the inclusion of a
draught stabilizer in the installation, Alternatively
(recommended) a chimney cowel, designed to stabi-
liser flue conditions. The Aerocowel is one such cowel
sold for this purpose.
Fig. 1
2.1. CONFIGURATION OF THE SMOKE
OUTLET
The stove can be configured with a rear or top outlet.
REAR FLUE OUTLET
When using the rear flue outlet, install the cover plate
protector (F) before inserting the chimney cap (D).
This protective plate (F) prevents damage to the chim-
ney cap.
Don't forget to place the gaskets (B and E).
Fig 2
EN
29
Publicité
