Publicité
EQ 0600BL
Press the stop button by user.
Store chip error
Not back the scale.
Step of calibration without 100g weight
inside or incorrect sensor connection
Incorrect length when scale calibration
Incorrect angle when scale calibration
Incorrect paremeter store
The scale is not at the original position when
turn on the machine.
Choose wrong spokes when hidden the
Chip damaged
MAINTENANCE
WARNING
The manufacturer will not bear any responsibility in the event of claims resulting from
the use of non original spare parts or accessories.
WARNING
Unplug the machine from the socket and make sure that all moving parts have been
locked before performing any adjustment or maintenance operation.
WARNING
Do not remove or modify any part of the machine (except for service interventions).
CAUTION
Keep the work area clean. Never use compressed air and/or jets of water to remove dirt
or residues from the machine. Take all possible measures to prevent dust from building
up or rising during cleaning operations. Keep the wheel balancer shaft, the securing ring
nut, the centering cones and fl ange clean. These components can be cleaned using a
brush previously dripped in environmentally friendly solvents. Handle cones and fl anges
carefully so as to avoid accidental dropping and subsequent damage that would aff ect
centering accuracy. After use, store cones and fl anges in a place where they are suitably
protected from dust and dirt. Perform the calibration procedure at least once every six
months.
MANUAL MOTORIZED WHEEL BALANCER LED
SCREEN
weight
Do anther balance operation again.
Change power board.
Back the scale and reset the machine.
Do the correct calibration or check sensor
connection or change the sensor.
Do the correct calibration or check the scale
wire connection or change scale board.
Do the correct calibration or check the scale
potentiometer wire connection or change the
potentiometer.
Change power board
Put the scale at original position
Choose two neighbouring spokes the outside
unbalance position.
Change C PU board
Publicité
