Publicité
EQ 0600BL
INTRODUCTION
The purpose of this manual is to provide the owner and operator
of this machine with a set of safe and practical instructions for the
use and maintenance of the wheel balancer. If such instructions
are carefully followed, the machine will off er you the levels of
effi ciency and duration. The following paragraphs defi ne the
levels of danger regarding the machine.
DANGER: Refers to immediate danger with the risk of serious
injury or death.
WARNING: Dangers or unsafe procedures that can cause serious
injury or death.
CAUTION: Dangers or unsafe procedures that can cause minor
injuries or damage to property.
Read these instructions carefully before using the machine.
Keep this manual and the illustrated materials supplied with the
equipment in a folder near the place of operation so as to allow
the machine operators to consult the documentation at any time.
The manual is only to be considered valid for the machine serial
number and model stated on the attached nameplate.
The instructions and information described in this manual must always be complied with: the
operator will be held responsible for any operation not specially described and authorized in
this manual. Some of the illustrations contained in this booklet have been taken from pictures of
prototypes: standard production machines may diff er slightly in certain respects. These instructions
are for the attention of personnel with basic mechanical skills. We have therefore condensed the
descriptions of each operation by omitting detailed instructions regarding, for example,
how to loosen or tighten the fi xing devices. Do not attempt to perform operations unless properly
qualifi ed or with suitable experience. If necessary, please contact an authorized Service Centre
for assistance. omitting detailed instructions regarding, for example, how to loosen or tighten the
fi xing devices. Do not attempt to perform operations unless properly qualifi ed or with suitable
experience. If necessary, please contact an authorized Service Centre for assistance.
INSTALLATION
Take the utmost care when unpacking, assembling, lifting and setting up the machine as indicated
below. Failure to observe these instructions can damage the machine and compromise the
operator's safety. Remove the original packing materials after positioning them as indicated on
the packaging.
All regulations in force concerning safety at work must be complied with when choosing the
installation position. In particular, the machine must only be installed and operated in protected
environments where there is no risk of exposure to dripping.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in the place of
use should be at least 300 lux.
Environmental operating conditions must comply with the following requirements:
• Relative humidity ranging from 30% to 80% (without condensation);
• Temperatures ranging from 0° to +50°C.
The fl oor must be strong enough to support a load equal to the weight of the equipment plus the
maximum load allowed. The machine must not be operated in potentially explosive atmospheres.
MANUAL MOTORIZED WHEEL BALANCER LED
SCREEN
Publicité
