Publicité
EQ 0600BL
INSTALLATION AND OPERATION
Before installation and use of the wheel balancer, you should carefully read this installation and
operation manual. And keep this manual in hand for reference at any time. You should be sure that
all the operators have read this manual to guarantee the most perfect functions of the machine
and meanwhile the safety.
Main shaft installation
Before
installation,
compressed air to clean up the center hole of the shaft
and connect part. Use spannerand screw to fi x the
thread shaft on the balance shaft (Fig2)
Electrical connection & earthing
According to the label on the connection between power cable
and body, the power cable connect socket
must be grounded with the reliable earth wire.
All the electrical devices installation must be done by
the qualifi ed staff . Before installation, please check if the power
system is complying with the technical parameter marked on the nameplate of the machine. The
wiring of the machine must have the fuse and the perfect ground protection. And install the
electrical leakage automatic controls switch in the power source. And recommend the application
of the stabilizer if the voltage of installation site is unstable.
Any electrical connect in the workshop is only done by the qualifi ed technical staff s and it should
meet the enforced regulation. Any electrical connect must be according to the following:
• Power on the data plate on the machine;
• Voltage decrease cannot exceed 4% of the rated voltage on the data plate when full load (10%
when start)
-Operators must:
• Install the plug;
• install 30ma circuit breaker;
• install power cable fuse;
• provide with eff ective workshop electrical connect to ground;
• prevent the authorized operation and pull out the plug to prolong the working life when not use
the machine.
• If the machine directly connected to the power source through the power board not the plug, we
should use the qualifi ed staff s to operate.
Perfect ground is necessary for the correct operation. Do not connect the machine with air pipe,
water pipe, telephone line and the other unsuitable objects.
TECHNICAL FEATURES
Features
• software with the feature of high intelligence and high stable
•mechanical main shaft adopts high precision bearing driven, wear-resistant, low noise
• press stop key to realize the emergency stop
• full automatic dynamic/static balance check
• balance 3 ALU rim and 1 motorcycle tire
• self-calibration and full automatic trouble diagnosis
MANUAL MOTORIZED WHEEL BALANCER LED
SCREEN
use
the
ethyl
alcohol
and
FIG 2
Publicité
