Electromagnetic Immunity - OSYPKA PACE 203 H Manuel D'utilisation

PACE 203 H

Electromagnetic Immunity

Standard: IEC 60601-1-2: Table 2
PACE 203H is intended for use in an electromagnetic environment as described below. The user should
make sure that PACE 203H is used in such an environment.
Testing the
Immunity to
Interference
 6 kV contact
Electrostatic
discharge (ESD)
IEC 61000-4-2
 2 kV for power
Fast transient
electrical
interference /
bursts according
to
IEC 61000-4-4
 1 kV differential
Surge voltages
(surges)
according to IEC
61000-4-5
common mode
Voltage drops,
brief interruptions (>95 % dip in U
and fluctuations
on power supply
lines according to
(60 % drop in U
IEC 61000-4-11
(30 % drop in U
(>95 % drop in
for 5 seconds
Magnetic field at
the supply
frequency (50/60
Hz) according to
IEC 61000-4-8
NOTE U
T
Table 67: Guidance and manufacturer's declaration – electromagnetic immunity I
PACE 203H V2.0
Test Level Compliance
according to Level
IEC 60601
 6 kV contact
discharge discharge
 8 kV air  8kV air
discharge discharge
 2 kV for power
supply lines supply lines
 1 kV for
Not applicable
(lines have a
input / output
length of less
lines
than 3 m)
 1 kV
mode differential mode
 2 kV  2 kV
common mode
<5 % U Not applicable
T
)
T
for 0.5 cycle
40 % U
T
)
T
for 5 cycles
70 % U
T
)
T
for 25 cycles
<5 % U
T
U )
T
3 A/m 3 A/m
is the AC voltage prior to application of the test level
Guidelines for the
Electromagnetic Environ
ment
Floors should be made of
wood, concrete or
ceramic tiles. If floors
consist of a synthetic
material, the relative
humidity should be at
least 30 %.
Quality of power supply
lines should be that of
typical commercial or
hospital environment.
Quality of power supply
lines should correspond
to levels typical of
commercial or hospital
environments.
Not applicable
(PACE 203H has an
uninterruptible power
supply)
The magnetic field
strength should
correspond to levels
typical to commercial or
hospital environments.
Page 124 of 136