Publicité
3. Insert the solar cell housing
shade
. For model B and C please tighten
2
the solar cell housing
4. Place the lamp shade
5. Take out the ground stake
and insert the ground stake
with the tip facing downwards (see Fig. C).
6. Your product is ready for use (see Fig. D).
Setting up the product
Insert the assembled product far enough into the
ground (lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance
at all times. Do not use any force when assem-
bling or setting-up the product, e.g. hammer blows.
This will damage the product. In order to achieve
the best result, set the product up in a place
where the solar cell will get direct sunlight for
as long as possible.
Make sure that the solar cell is not influenced by
any other source of light such as yard or street
lighting as otherwise the light will not come on
in twilight.
The light automatically switches on in twilight
conditions and off again when normal outdoor
lighting conditions return.
Replacing the
rechargeable battery
The rechargeable battery should be replaced every
12 months to ensure optimum performance.
1. Separate the solar cell housing
lamp shade
2
solar cell housing
Switch off the light with the ON/OFF switch
2. Loosen the fastening screws
cross head screwdriver and then lever out the
battery compartment lid
housing
with the help of a slot screwdriver
1
(see Fig. B).
3. Take care not to damage the cables and cable
connections (see Fig. B).
4. Exchange the old rechargeable battery
a new one. Take care about the correct polarity,
when inserting the new rechargeable battery.
8
GB/IE/NI
into the lamp
1
by turning it clockwise.
1
on to the pole
2
from the pole
4
into the pole
4
from the
1
. For model B and C move the
anti-clockwise (see Fig. A).
1
by using a small
6
of the solar cell
7
The polarity is indicated in the battery compart-
ment. The new rechargeable battery has to
have the same technical data like the old one
.
(see "Technical data").
3
5. Now again fasten the battery compartment lid
3
fasten the fastening screws
3
cross head screwdriver. Slide the ON/OFF
switch
5
6. Connect the solar cell housing
lamp shade
the product to each other (see Fig. C).
Charging the
rechargeable battery
Note that the product must be switched on when
the rechargeable battery is charging. The charging
time of the rechargeable battery when the solar
cell is used depends on the intensity of the sunlight
and the angle of incidence of the light on the solar
cell. Place the solar cell as perpendicular as possible
to the angle of incidence of the light. In this way
you will receive the highest light levels.
Maintenance and care
The LED cannot be replaced. The product is mainte-
nance-free, except for any necessary change of
rechargeable battery.
Clean the product regularly with a dry, lint-free
cloth. Use a slightly dampened cloth to remove
more stubborn dirt.
Troubleshooting
.
5
Note: This product has delicate electronic compo-
nents. This means that if it is placed near an object
that transmits radio signals, it could cause interference.
If you notice that the product is malfunctioning, remove
any sources of interference from the area of the product.
Note: Electrostatic discharges may cause the prod-
uct to malfunction. In the event of such malfunctions,
to
remove the rechargeable battery briefly and reinsert it.
8
by using a small
6
to the position ON.
1
and then connect every part of
2
,
7
again to the
Publicité
