HOLZMANN MASCHINEN HOB410PRO 400V Mode D'emploi page 49

Machine stops during operation
Machine vibrates during
operation
Workpiece clamps during
thicknessing
Bad surface condition after
operating
Rough surface after operating
Cracked surface after operating
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
 Blunt blade
 Feeding speed to high
 Motor protection triggered
 Wrong adjusted blade
 Ground not flat or base feet
wrong adjusted
 Cutting depth to high
 Dirty thicknessing table
 Blunt blade
 Uneven feed of the workpiece
 Workpiece too moist
 Workpiece was processed
against the direction of growth
 Cutting depth to high
TROUBLESHOOTING
Check blade

Work with lower feeding

speed
Let the motor cool down

Check the setting of the

blades
Set the base feet correct

Set the correct cutting

depth and operate in more
steps
Clean and apply the table

surface with lubricant
Check blade

Feed workpiece evenly and

with constant pressure
Use drier workpiece

Proceed the workpiece in

opposite direction
Set the correct cutting

depth and operate in more
steps
HOB410PRO_400V | HOB410PROSMW4_400V
49