Publicité
18.10 Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Disconnect the
machine from the power supply. Make sure that unauthorised persons and especially children do
not have access to the machine.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil (e.g.
WD40 rust inhibitor).
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
18.11 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the power supply. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem.
Problem
Machine does not start or shuts
down automatically during idling
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
7.
If the cutter insert will be turned, clean it thoroughly as well
NOTE:
A cutter insert can be turned 3 times (refer to numbers
(5) for help)
8.
Now renew the cutter insert, or turn it over to the next
number
NOTE:
As an aid, it is advisable to always insert a new cutter
insert with the starting point (6) at the same position
9.
Fix the cutter insert with the screw for cutter inserts.
(Recommended minimum tightening torque 4Nm)
N O T E
W A R N I N G
Possible cause
Power supply outage
Damaged or incorrect
connected extension cable
Damaged switch or motor
TROUBLESHOOTING
Solution
Check fuse of the power
supply
Check plug or extension
cable
Contact customer support
HOB410PRO_400V | HOB410PROSMW4_400V
48
Publicité
