Publicité
16.7.1
Converting from planer to thicknessing
For readjusting to planer mode please lower the thicknesser table to lowest position
to avoid any damages.
16.7.2
Thicknessing of workpieces
working direction
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Slide the planer fence (1) all the way to the back.
• Disassemble the hose of the dust collector plug (2).
• Unlock the fixation planer tables (3) of the planer
tables. Therefore pull out and turn the star screw
• Unfold the planer tables (4) completely.
• Turn down the dust collector hood (5).
• Mount hose to the dust collector plug (6).
Proceed in reverse order to readjust to the planer
mode.
N O T E
• Unlock the locking lever height adjustment thicknesser (1) and
set the required height of the thicknessing table with the
handwheel (2).
• The height will be shown on the scale and counter block (3).
• Set the thicknessing table height to the workpiece height
minus the requested cutting depth.
• Maximum cutting depth refer to the technical data!
NOTE:
At the beginning of the thicknessing process, the
workpieces may still have very different thicknesses - this must
be taken into account in the set cutting depth in order not to
overload the machine.
• Fix the thicknessing table height with the locking lever height
adjustment.
• Switch on the machine.
• Put the lever for thicknesser feeder (4) to the upper position to
start the feed.
• Insert workpiece so that the surface to be machined facing
upwards and push forward
• The workpiece is pulled through of the automatic feed
• As soon as the half of the workpiece has been processed
change to the opposite operator side of the machine and take
on the finished workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a standstill!
OPERATION
HOB410PRO_400V | HOB410PROSMW4_400V
43
Publicité
