Publicité
18.8 Replacing/adjusting the planing knife (HOB410PRO)
The planer shaft is suitable for strip knives.
If the planing surface is bad, the planing knives must be replaced. The appropriate
dimensions can be found in the technical data.
Danger from cutting edges! Always wear protective gloves when working on the
planing shaft! Injuries to hands due to sharp cutting edges
18.9
Replacing/turning the cutter insert (HOB410PROSMW4)
The spiral cutter head is suitable for cutter inserts.
If the planing surface is bad, only the damaged or blunt cutter insert needs to be
replaced/turned.
The appropriate dimensions can be found in the technical data.
Danger from cutting edges! Always wear protective gloves when working on the
spiral cutter
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T E
W A R N I N G
1.
Adjust the machine to thickness planing mode
2. The dust collection hood must be open in order to have access to
the shaft
3. Loosen the gib screws (1)
4. The planing kife (3) will be pushed up by the pressure springs (5)
5. Remove the gib (2) and the planing knife (3)
6. Clean the planer shaft (4) and gibs (2)
7. Replace sharpend/new planning knife (3) and gib (2)
8. Slightly tighten the gib screws (1) and and perform the
adjustment procedure.
9. Place the setting gauge (6) on the planning shaft and adjust the
correct height.
10. Tighten the gib screws (1) to fix the gib (2) (recommended
minimium tightening torque 20Nm)
11. Do not use planning knives with a height of less than 19mm due
to the too small clamping surface
12. Repeat procedure for all planing knives.
N O T E
W A R N I N G
head! Injuries to hands due to sharp cutting edges
1.
Adjust the machine to thickness planing mode
2.
The dust collection hood must be open in order to have
access to the spiral cutter head (1)
3.
Remove wood chips and dust from the heads of the screws
for cutter inserts (2)
4.
Unscrew the screw for cutter inserts with the key for inserts
(3)
5.
Remove the cutter insert (4)
6.
Thoroughly clean the place of the cutter insert on the spiral
cutter head
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOB410PRO_400V | HOB410PROSMW4_400V
47
Publicité
