Publicité
16.6.2
Planing with tilted planer fence
16.6.3
Planing short workpieces
16.6.4
Planing the workpiece with small cross section
16.7
Thicknessing
It is necessary to modify/adjust the machine before using as a thicknesser.
Long, protruding workpieces must be sufficiently supported! Use suitable aids such as roller
•
blocks etc. for this purpose. If you do not follow these instructions, there is a danger of the
workpiece being raised up quickly and/or the machine being tilted!
•
Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
For workpieces with a difference in thickness, the chip removal must be measured at the
•
maximum thickness and the workpiece machined with this side first.
Make sure that the workpiece to be machined is free of foreign objects and/or knots in
•
order to avoid dangerous fractures.
Only plane workpieces that rest firmly on the machine and can be guided safely!
•
If several workpieces are to be processed in series, all pieces of the same thickness should
•
be run through in succession without changing the setting.
Perform the machining process from the beginning until the desired thickness is achieved.
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Lower the planer knife cover so that the planing shaft is
covered.
• Move the planer knife cover to the workpiece and fix it with
a distance of approx. 5mm.
• When planing, place the workpiece with the small side on
the planer table and press with one hand against the planer
fence and planer table.
• Push the workpiece slowly and evenly over the shaft with
the second hand.
• When planing short workpieces, a sliding wood or similar
device should be used!
• Adjust planer fence and blade guard to the size of the
sliding wood.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
• After use, the sliding wood must be reattached on his place
on the side of the machine.
• When planing workpieces with a small cross-section, an
additional wood angle must be mounted!
• Fasten the wood angle to the planer fence as shown using
lever clamps.
• When planing, place the workpiece on the planer table and
press it against the additional wood angle and planer table.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
N O T E
OPERATION
HOB410PRO_400V | HOB410PROSMW4_400V
42
Publicité
