Publicité
At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1. Turn off the solenoid valve switch (3).
2. Turn off the suction switch (2).
3. Turn off the brush / main switch (1).
4. Raise the rear handle to lift up the squeegee.
5. Take the machine to the location designated for draining the water.
6. Remove the recovery tank, then remove the bayonet cap and tilt the tank to empty it.
7. Remove the solution tank, then remove the filler cap and tilt the tank to empty it.
8. Disassemble the brush and clean it with a jet of water (to disassemble the brush, see
"DISASSEMBLING THE BRUSH" below).
ATTENTION: This operation must be carried out wearing gloves to protect
against contact with dangerous solutions.
AT THE END OF THE WORK
ENG - pag. 18
1
2
3
Publicité
