Publicité
4. INSERTING/CONNECTING THE BATTERIES
In the CB version, the machine is supplied with a built-in battery charger and an airtight gel battery. If
you use batteries other than those supplied with the machine, use only BATTERIA LI-ION 12V 50Ah
and proceed as follows.
The batteries must be housed in the special compartment beneath the solution tank.
To insert the batteries you must:
1. Disconnect the quick connector (1) located in the front part of the solution tank.
2. Remove the solution tank and place it on the ground.
3. Open the two rear hinges (2) that close the battery compartment.
4. Turn the handlebars, rotating the handlebar movement lever.
5. Position the battery inside the compartment.
6. Connect the cables.
ATTENTION: You are advised to use airtight batteries only, to avoid the
leakage of acids!
ATTENTION: All installation and maintenance operations must be carried out
by expert personnel, trained at the specialised assistance centre.
ATTENTION: users are advised to always wear protective gloves, to avoid the
risk of serious injury to hands.
ATTENTION: you are advised to only lift and move the batteries with lifting
and transportation means suitable for the specific weight and size.
PREPARATION OF THE MACHINE
ENG - pag. 10
1
2
Publicité
