Publicité
Install the mount onto a strong structure.
Prepare the Junction box base and the accessaries for installation.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Route the Power/Video cables through the grommets from the wall. Insert the
grommets onto the Junction box base.
3. Place the Junction box base on pre-drilled position and fix it through using
mounting screws (4x30mm).
4. Connect the cable wiring with wiring connector.
5. Fix the cable fixation plate and tie up the cable to it.
6. Hook up the Junction box top with the Junction box base by the hinge pin.
7. Connects the Power/Video cables from camera as illustrated. Fix the Power/Video
cables from camera to junction box base using the supplied screw.
8
Publicité
