Publicité
14. Troubleshooting
Fault
Possible cause
Motor does not work
Motor, cable or plug defective, fuses burnt
The motor starts up
Voltage too low, coils damaged, capacitor
slowly and does not
burnt
reach operating speed.
Motor makes excessive
Coils damaged, motor defective
noise
The motor does not
Circuits in the network are overloaded (lamps,
reach its full power.
other motors, etc.)
Motor overheats easily.
Overloading of the motor, insufficient cooling
of the motor
Reduced cutting power
Saw blade too small (ground too much)
when sawing
Saw cut is rough or
Saw blade dull, tooth shape not appropriate for
wavy
the material thickness
Workpiece pulls away
Excessive cutting pressure and/or saw blade
and/or splinters
not suitable for use
24
GB
All manuals and user guides at all-guides.com
Remedy
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor
Readjust end stop of the saw unit
Resharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
Publicité
