Power Supply; Setup And Initial Time Setting; Factory Configuration - Bodet Time Profil 960 Manuel D'installation Et De Mise En Service

III

- Power supply

NTP clocks are synchronized and powered by the Ethernet network (PoE).
IV

- Setup and initial time setting

1) Connect the Ethernet network on the RJ45 connector (A).
■ Ethernet cable category: 5 minimum or 6.
The type of synchronisation will have to be programmed in pages webserver of the clock. Find
the MAC address (B) which will be useful during the detection of the clock on the software Bodet
Detect to reappoint it.
2) Meaning of LEDs indicators on the RJ45 connector :
■ The green LED is on when the clock is powered on.
■ The yellow LED is blinking once per second when the clock is synchronised.
■ The yellow LED is blinking fast for 5 s then switching off for 3s when the clock is not
synchronised or no more synchronised for 1 hour.
■ The yellow LED is permanently switched on when you make a localization of the clock since
the software Bodet Detect.
V

- Factory configuration

The default configuration is as follows:
■ IP configuration by DHCP.
■ Time zone: EUR.
■ Multicast synchronisation.
■ Synchronisation adress: 239.192.54.1.
A reminder of this configuration is printed on the back of the product.
The full factory configuration is as follows:
■ Clock name: «BODET-@MAC».
■ IP configuration by DHCP.
■ Time zone: EUR.
■ Multicast synchronisation.
■ Synchronisation address: 239.192.54.1.
■ Pool period for unicast synchronisation: 15 mins.
■ SNMP disabled.
■ Trap type: V2C.
■ Temperature alarm threshold: –5°C to +55°C.
■ Trap status sending interval: 24H.
■ No password.
6
EN