Publicité
SAFETY INSTRUCTIONS
6
Installation
• Contact an authorized service centre when installing or relocating the
air conditioner.
• Do not install the air conditioner on an unstable surface or in a place
where there is danger of it falling.
• Do not install the unit in potentially explosive atmospheres.
• Do not install the air conditioner in a place where flammable liquids
or gases such as gasoline, propane, paint thinner, etc., are stored.
• Install the panel and the cover of the control box safely.
• Install a dedicated electric outlet and circuit breaker before using the
air conditioner.
• Use standard circuit breaker and fuse that conform to the rating of
the air conditioner.
• Make sure that the pipe and the power cable connecting the indoor
and outdoor units are not pulled too tight when installing the air
conditioner.
• The indoor/outdoor wiring connections must be secured tightly, and
the cable should be routed properly so that there is no force pulling
the cable from the connection terminals. Improper or loose
connections can generate heat or cause a fire.
• Do not connect the ground wire to a gas pipe, a lightning rod, or a
telephone ground wire.
• Use non-flammable gas (nitrogen) to check for leaks and to purge air;
using compressed air or flammable gas may cause fire or explosion.
Operation
• Do not modify or extend the power cable. Scratches or peeling
insulation on the power cables may result in fire or electric shock, and
should be replaced.
• Make sure that the power cable is neither dirty, loose, nor broken.
• Do not place any objects on the power cable.
• Do not place a heater or other heating appliances near the power
cable.
Publicité
