Publicité
User manual - English
7.2.2 Cleaning the storage container:
(Also see service video capitel 10. QR code)
If chapter 7.2.1 has already been carried out, continue with point 3.
1.
Start up the ice cube maker by switching on the
production switch (Position "Produktion ein/on").
2.
Switch off the machine at the production switch
(Position "Produktion aus/off").
3.
Remove any ice remaining in the storage
container. Ice intended for consumption must not come
into contact with the detergent!
4.
Remove the metal plate inserts for draining the
condensation water from the storage container.
5.
Thoroughly spray the storage container and the
metal plate inserts with WESSAMAT special cleaner
and allow a few minutes for the cleaner to act.
6.
Rinse the storage container and the metal plate
inserts with clear water in order to remove the special
cleaner
and
dissolved
remaining special cleaner residues with soap water. A sponge or cloth may be used for this
purpose.
7.
Plug in the socket
8.
Place the metal plate inserts into the storage container.
IMPORTANT:
Almost all cleaners contain acids which can cause corrosion. Therefore, all stainless
steel parts that have been treated with cleaner must be rinsed thoroughly.
!
CAUTION
The first two to three ice drops should be removed from the storage container after
cleaning. There is a risk that this ice may contain residues of cleaning agents and
therefore it is not suitable for consumption.
User-manual-BlueLine-v.02
deposits.
Neutralise
Fig. 7.1.2: Storage container display with insert
sheets
the
01/2021
63
Publicité
