Publicité
User manual - English
6.2
Height and thickness of the ice cubes
The height and thickness of the ice cubes produced
depends on the water level in the trough and on the ice
thickness motor setting. The water level is controlled
electronically via the water level sensor.
De The ice thickness motor checks the ice thickness
once every minute. Once the set ice thickness has
been reached, the ice thickness motors triggers the ice
thickness limit switch, thus initiating the defrosting
phase. The height and thickness of the ice cubes can
be modified by adjusting the water level sensor and the
ice thickness limit switch (see chapter 6.3 and 6.4).
IMPORTANT:
Always adjust the ice thickness after the third ice production cycle. Only then does
the machine stabilize its ice production.
6.3 Setting the ice cube thickness
Switch off the machine at the production switch (Position "Produktion aus/off") and
1.
pull the power plug. Remove the machine cover and the cover of the technical equipment
box (marked with a flash symbol).
User-manual-BlueLine-v.02
Ice thickness limit switch
Water level
sensor
Ice control
motor plate
Fig. 6.2: Side view of ice thickness
motor and water level sensor
01/2021
Ice thickness
motor
Pivot
point
Lever
57
Publicité
