Publicité
GB
10-7
10-8
10.6.3 Drain hose to sink connection
The junction must lie above the siphon.
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 10-9).
Secure the drain hose with a clamp.
CAUTION!
The drain hose should not be submerged in water and should be securely xed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being lled (self-si-
phoning).
Drain hose is not to be extended. If necessary contact after sales service.
10.7 Fresh water connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled
end to the appliance (Fig. 10-10). Tighten the
screw joint by hand.
2. The other end connect to a water tap with a
3/4" thread (Fig. 10-11).
Note: Aqua-stop system:
Some models are equipped with an aqua-stop inlet hose (B).The aqua-stop system
protects against water damage by automatically cutting the fresh water supply in case
of a leaking hose. This is indicated by a red marker (C). The hose must be replaced.
10-Installation
Following connections are possible:
10.6.1 Drain hose to sink
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-7).
ping.
10.6.2 Drain hose to waste water connection
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the
wastewater pipe.
(Fig. 10-8).
10-9
10-11
10-10
-
27
Publicité
