Télécharger Imprimer la page

Haier HW90-BP14636N Mode D'emploi page 17

Publicité

GB
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-8) to start. The LED
of the "Start/Pause" button stops flashing and lights
up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2.
3.
Press "On/Off" button to turn on the appliance,select programme Spin and then se-.
lect "no Speed"(speed lights are off) ,start the machine to drain the water.
4. After closing th e program to restart the appliance,select a new programme and start it.
6.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; Loc 1- is displayed.
1. At programme cycle end EnD is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if it will not be activated within 2
This saves energy. To interrupt the standby mode push "Start/Pause" button.
6.13 Activate or deactivate the buzzer
The acoustic signal can be selected if necessary:
1. Switch on the appliance.
2. Select the SPIN programme.
3. Press the "Delay "button and "Extra rinse" button at the same time for about 3 sec-
onds. " bEEP OFF " will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. "bEEP On"
will be displayed.
6-Daily use
Start/Pause
6-8
17

Publicité

loading

Ce manuel est également adapté pour:

Hw80-bp14636nHw80-bp16636n