Publicité
9-Troubleshooting
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code
Message
The remaining wash cycle time will be 1 hour and 25 minutes.
1:25
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
6:30
utes.
1/2/3 additional rinses are choosen (see FUNCTION BUTTONS "Extra rinse").
P--1/2/3
End
Function child lock is activated.
cLo 1-
Door is closed because of high water level, high water temperature or spinning cy-
Loc
1-
cle.
The buzzer is deactivated.
bEEP OFF
The buzzer is activated.
bEEP ON
Function "Speed up" is activated.
SPEEd
up
9.2 Troubleshooting with display code
Problem
Cause
• Drainage error.
CLR FLTR
• Lock error.
E2
•
Water level not reached.
E4
• Drain hose is self-syphoning.
• Water protective level error.
E8
22
Solution
•
• Check drain hose installation.
• Shut the door properly.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Contact the After sales service.
GB
Publicité
