Télécharger Imprimer la page

Haier HW90-BP14636N Mode D'emploi page 23

Publicité

GB
Program
Cause
Water level sensor error.
FA
• Temperature sensor error.
F3
• Heating error.
F4
• Motor error.
F7
• Abnormal communication error.
FC0、
FC1
or FC2
• Unbalanced load error.
UnB
9.3 Troubleshooting without display code
Problem
Washing machine fails
to operate.
Washing
machine
water.
Machine is draining • Height of drain hose is below 80 cm.
Drainage failure.
Strong vibration while
spinning.
Operation stops
before completing
wash cycle.
Operation stops for
a period of time.
Cause
• Programme is not yet started.
• Door is not properly closed.
• Machine has not been switched on.
• Power failure.
• Child lock is activated.
• No water.
• Inlet hose is kinked.
• Water pressure is less than 0.03 MPa.
• Door is not properly closed.
• Water supply failure.
• Drain hose end could reach into
water.
• Drain hose is blocked.
• Drain hose end is higher than 100 cm
above floor level.
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Water or electric failure.
• Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
9-Troubleshooting
Solution
Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
C
e h
k c
a
d n
b
Reduce the load.
Solution
• Check programme and start it.
• Close the door properly.
• Switch the machine on.
• Check power supply.
• Deactivate child lock.
• Check water tap.
• Check inlet hose.
• Check water pressure.
• Close the door properly.
• Ensure the water supply.
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not
in water.
• Unblock drain hose.
• Make sure that drain hose is
properly installed.
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
• Check power and water supply.
• Consider display codes.
• Reduce or adjust load.
• Cancel programme and restart.
l a
n a
e c
a l
n u
r d
l y
a o
i d
t n
e h
d
u r
. m
23

Publicité

loading

Ce manuel est également adapté pour:

Hw80-bp14636nHw80-bp16636n