Publicité
E
N
Control horn and servo arm settings
The table shows the factory settings for the control horns
and servo arms. Fly the aircraft at the factory settings
before making changes.
After flying, you may choose to adjust the linkage positions
for the desired control response.
Linkage rods installation
Before installing the main wing, horizontal tail and vertical tail, the linkage rods for ailerons, flaps, elevators and rudder
should be installed in advance.
Make sure the servos are in neutral position. Attach the "Z" bend end of aileron, flap, elevator and rudder linkage rods
to the corresponding holes in the aileron, flap, elevator and rudder control arms from the outside as shown (Please refer
to the control horn and servo arm settings and clevis installation sections in manual ). And then install the clevis (or ball
buckle) at the other end of the linkage rods to the corresponding hole (or ball head) at each control horn on control
surfaces.
ball head
Check the C.G. (Center of gravity)
When balancing your model, adjust the battery as neces-
sary so the model is level or slightly nose down. This is the
correct balance point for your model. After the first flight,
the CG position can be adjusted for your personal prefer-
ence.
1. The recommended Center of Gravity (CG) location for
your model is(50-60mm) from the leading edge of the main
wing (as shown) with the battery pack installed. Mark the
location of the CG on top of the wing.
2. When balancing your model, support the plane at the
marks made on the bottom of the main wing with your
fingers or a commercially available balancing stand. This is
the correct balance point for your model. Make sure the
model is assembled and ready for flight before balancing.
Horns
Clevis
10
More control throw
Arms
Less control throw
50mm-60mm
Publicité
