Publicité
Preliminary measures before
start up
Unit setup
To guarantee safe and trouble-free unit operation, choose
a setup location which meets the following requirements:
- The floor should be firm, flat and horizontal.
- Observe the following minimum clearances
from the unit housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and 50
cm from its front side.
- Do not place the unit in a hot and wet or very hu-
mid environment or near combustible materials.
- The socket should be easily accessible so that
the mains connection cable
disconnected if necessary.
Please note: The unit may produce a slight odour
for a short time when used for the first time.
Start up
Switching on/off
Make sure that the three heat level switches
and
are set to "0". Then connect the heater
4
to a grounded socket protected by a residual-
current device with overload protection. The heating
unit must be freely rotatable.
Now switch on the unit by switching the on/off
switch
to the "I" position. To turn off the unit,
4
switch the on/off switch
Please note: When the unit is switched on, the middle
heating element
is activated.
7
24
GB/IE
can be easily
12
,
2
3
to the "0" position.
4
Heating levels
The halogen heating unit has three different
heating levels: 400W, 800W and 1200W.
The first heating level (400W) is reached when the
unit is switched on. In the process, the central heat-
ing element
is put into operation (see chapter
7
Switching on/off).
The second heating level (800W) is reached by
additionally switching one of the heating level
switches to on (
or
2
Please note: The heating level switch
lower heating element
8
switches the upper heating element
3
The third heating level (1200W) is reached by ad-
ditionally switching both of the heating level switches
to on (
&
).
2
3
Oscillation
Set the oscillation switch
function. The heater fan will begin to move from
side to side.
To disable the oscillation, switch the oscillation
switch
to "0".
1
Overheating protection
This unit is equipped with an overheating protec-
tion device. If the unit is too hot, the heating elements
(
-
) switche off automatically. Turn the unit OFF
6
8
by turning the heating level switch
pull the power plug out of the socket. Please note:
If the overheating protection is triggered, you should
turn OFF the unit and contact the service hotline (see
chapter "Service").
).
3
switches the
2
on. The heating level switch
on.
6
to "I" to activate the
1
to "0" and
4
Publicité
