Velleman HAA920 Notice D'emploi page 32

9.3 Data collection
9.3.1 Using RS232/RS485
• Plug the included data cable into the RS232/RS485 port [4] and connect the
other end to a regular COM port of your PC.
• Go to "Figure device" (left column) and select "Figure Communications".
• Select communication type RS232/485 and set the COM port and BAUD rate
to match those on your computer (refer to the introduction of §9).
• Click "connect". Continue with §9.3.4.
9.3.2 Using TCP/IP
• Plug a regular Ethernet cable (crossed, not incl.) into the TCP/IP port [3]
and plug the other end into your PC.
• Select communication type TCP/IP and set the IP address to match that on your computer (refer to
the introduction of §9).
• Click "connect". Continue with §9.3.4.
9.3.3 Using the USB port
• This model does not support a direct connection between the USB port [1] and a computer.
However it is possible to download data on a USB memory card (not included) to transfer it to a
computer (refer to §5.10.2.3).
19.08.2014 – v. 3
HAA920
32
©Velleman nv