Publicité
> Press
upper alarm value, lower alarm value, battery life and last
reading.
-
These are shown in the specified sequence in the display.
✓ Operating status
> Press
highest saved reading, lowest saved reading, upper alarm
value, lower alarm value, battery life and last reading.
-
These are shown in the specified sequence in the display.
6
Using the product
6.1
Programming data logger
In order to adapt the programming of your data logger to your
individual requirements, you require the testo ComSoft software. It
is available in the Internet as a free download requiring registration
www.testo.com, International,
Center.
6.2
Mounting wall bracket
✓ Data logger is removed from the wall bracket (see Releasing
data logger page 24).
1. Position wall bracket at the desired location.
2. Using a pen or similar, mark the location for the fastening
screw.
3. Prepare the fastening location for the attachment in accordance
with the material (e.g. drill hole, insert anchor plug).
4. Fasten wall bracket using an appropriate screw.
GO
button in order to change between displays of the
Rec
GO
button in order to change between displays of the
The instructions for the installation and operation of the
software can be found in the testo ComSoft instruction
manual that is downloaded together with the software.
Mounting materials (e.g. screws, anchor plugs) are not
included in the delivery.
or End:
Service&Support
6 Using the product
|
Download
29
Publicité
