Function "Scan": Skipping Channels Already Being Used When Selecting Channels; Function "Sq": Setting The Squelch Value; Function "Att; Level Attenuation For The Xlr Output - Monacor International JTS US-36G2/5 Mode D'emploi

2) Press the button SET
3) The last three digits of the transmission fre-
quency start flashing: Use the button
to set the frequency in steps of 0 025 MHz
If the frequency is identical to the fre-
quency of a channel in a group, the group
number and the channel number will appear
on the display
Note: When the frequency has been set and the
setting mode is called up again to select another
function, the group /channel number will disap-
pear It will reappear when the receiver is switched
on again
4) To save the setting, press the button SET
6.3 Function "SCAN":
Skipping channels already being used
when selecting channels
When this function is selected,
ing on the display
When the function has been activated, the
receiver will check during channel selection
( chapter 6 1, step 3) if this frequency is al-
☞
ready being used for transmission (meanwhile
the display will indicate
is being used, the next free channel will be se-
lected automatically
If the group does not offer any free chan-
nel, the display will indicate
select another group
1) To activate the function, use the button
select the setting
To deactivate the function, use the button
to select the setting

2) To save the setting, press the button SET
6.4 Function "SQ":
Setting the squelch value
When this function is selected,
letters "SQ" start flashing on the display
The squelch threshold is adjustable The squelch
function will mute the receiver when the level of
the radio signal falls below the threshold value
Thus, interference signals will not cause noise
when the transmitter is switched off or when
12
its radio signal is poor: If the levels of the inter-
ference signals are below the threshold value,
the receiver will be muted
or
 
ference resistance, but it will also reduce the
transmission range: If the strength of the radio
signal from the transmitter falls below the value
adjusted, the receiver will also be muted
1) Use the button
2) To save the setting, press the button SET

6.5 Function "ATT":

When this function is selected,
ing on the display
When the function has been activated, the sig-
starts flash-
nal level at the XLR output will be attenuated
by 20 dB and the XLR output can be connected
to a microphone input
1) To activate the function, use the button
) If the channel
2) To save the setting, press the button SET
In this case,

6.6 Function "LOCK": Key lock

to

When this function is selected,
ing on the display
Activating the key lock:
1) To activate the function, use the button
2) To save the setting, press the button SET
Deactivating the key lock:
and the
1) Keep the button SET pressed for 3 seconds
2) To deactivate the function, use the button
3) To save the setting, press the button SET
A high threshold value offers high inter-
or

threshold value: The higher the number
(–5 ... +10), the higher the threshold value

Level attenuation for the XLR output

select the setting
on the display
To deactivate the function, use the button
to select the setting

select the setting
on the display
to call up the setting mode and to select the
function "LOCK"
to select the setting
to set the desired

starts flash-

; "ATT ON" will appear
starts flash-

; "LOCK" will appear
to
to
