Lighting The Unit; Turning Off The Gas To The Unit - Laars NeoTherm NTH Série Manuel D'utilisation

Page 4

LIGHTING THE UNIT

1. STOP! Read the safety information listed above.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the unit.
4 This unit is equipped with an ignition device which automatically lights the burner. Do not try to light the
burner by hand.
5. Remove the front access panel.
6. Turn OFF the manual gas valve. The valve is off when the valve handle is at a right angle to the gas pipe.
7. Wait five minutes to allow any gas to clear. If you do smell gas, STOP! Follow Step B in the safety
information listed above. If you don't smell gas, go to the next step.
8. Slowly turn the manual gas valve to ON. The handle on the valve will be parallel to the gas pipe.
9. Replace the front access panel.
10. Turn on the electric power to the unit.
11. Set the thermostat to the desired setting.
12. If the unit will not operate, follow the instructions in "Turning Off the Gas to the Unit" and call your service
technician or gas supplier.

TURNING OFF THE GAS TO THE UNIT

1. Before doing any service work, turn off all electric power to the unit.
2. Set the thermostat to the lowest setting.
3. Remove the front access panel.
4. Turn OFF the manual gas valve. The valve is off when the valve handle is at a right angle to the gas pipe.
5. Replace the front access panel.
LAARS Heating Systems
Gaz Inlet
Manual gas valve
shown in the OFF position
Manual gas valve