Publicité
4. Inspection - Storage
4 1
Upon receipt of the model immediately check its state of integrity; immediately dispute with the transport company any
damage. The packaging is created according to the model, to the suitable means of transport and of handling.
4 2
The heat exchangers of the condensers (VGK) and the gas coolers (VGS) are supplied with a pre-charge of dry air at 2
bar and have load couplings of 1/4" SAE. Check for the presence of pressure. In the absence of pressure immediately
contact Modine and report the problem on the transport document. Insufficient pressure indicates a loss due to damage
incurred during transportation.
4 3
The model must be stored in its original packaging in a place that is protected and away from weathering.
4 4
Do not place any other material on top of the packaging.
4 5
If a motor fan is switched OFF for a long period of time, it must be switched ON for at least 2 hours every month to remove
any traces of condensation that may have formed inside the motor.
4 6
The following rules apply when the unit must remain in storage for long periods of time. The unit must be stored indoors
and positioned according to its working position. This ensures functionality of the drainage holes of the fans. With the unit
stored in a damp environment, it is necessary to examine the outer covering to make sure that there are no damaged
points. If any are found, have them repainted. The fans must be protected with plastic reinforced sheeting or with some
other mechanical protection against water and/or contaminants which could damage the motors. The free surface of the
finned pack must be mechanically protected with a panel or with something similar. On VGW models, the connection
couplings, if open, should be closed by blank flanges or steel plate covers, which seal the connection headers by means
of rubber gaskets. During storage, the fans must be manually rotated at least once every 3 months.
30
www.modine.com
Figure 2
Publicité
