Publicité
Les langues disponibles
Les langues disponibles
˜ Ending ironing
1. Turn the temperature control
clockwise all the way to MIN.
2. Set the steam control
steam) position. Set down the product with
the base
on an even, stable surface.
9 ]
[
3. Disconnect the mains plug
socket-outlet.
4. Let the product cool (this takes approximately
15 minutes). Do not leave the product
unattended while it is still hot.
5. To prevent limescale build-up, empty the
water tank after each use. To do so, open
the lid of the fill opening
water tank via the fill opening
the iron upside down over a sink.
˜ Additional product features
Automatic shut-off
The product is equipped with an automatic
o
shut-off system.
If the product is resting or not moving in
o
upright position (approx. 8 minutes) or in
horizontal position (approx. 30 seconds),
an alarm tone sounds 6x and the control
light
flashes. The product stops heating
[
7 ]
up.
To deactivate the automatic shut-off, lift the
o
product and move it gently from side to side.
The control light
7 ]
[
heats up again.
NOTES:
The automatic shut-off is not intended as a
o
substitute for removing the mains plug
from the socket-outlet.
The automatic shut-off is intended to reduce
o
the fire hazard if you forget to switch off the
product.
Anti-drip system
The product features an anti-drip system.
o
This prevents water from exiting from the
soleplate
as long as the temperature
1 ]
[
is too low to produce steam. This feature
prevents water stains on your clothing.
12 GB/IE/NI
counter-
10 ]
[
to the
(no
[
4 ]
from the
8 ]
[
. Empty the
3 ]
[
by holding
goes off and the product
8 ]
[
Anti-lime filter
Do not use any additives. Additives may
damage the water filter.
The product features an anti-lime filter. This is
o
a permanent water filter. It is not in need of
replacement or maintenance.
˜ Cleaning and care
DANGER! Risk of electric shock!
Always disconnect the mains plug
the socket-outlet before cleaning the product.
WARNING! Do not immerse the product's
m
electrical components in water or other
liquids. Never hold the product under
running water.
Do not let any water or other liquids enter
the product interior.
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product.
1. Wipe down the product with a slightly damp
cloth.
2. Clean the soleplate
and a mild, non-scouring detergent.
3. Let all parts dry completely after cleaning.
˜ Self-cleaning function
DANGER! Risk of electric shock!
Always disconnect the mains plug
the socket-outlet before filling the water tank.
The product features a self-cleaning function
o
to remove filth and limescale build-up in the
steam channels.
Use the self-cleaning function at least twice
o
per month.
If you use tap water: Use the self-cleaning
o
function after every use.
1. Before filling water into the water tank: Set
the steam control
4 ]
[
position.
2. Open the lid of the fill opening
Never fill the water tank past the max
mark
.
11 ]
[
3. Turn the temperature control
clockwise all the way to MIN.
4. Plug the mains plug
socket-outlet.
from
8 ]
[
using a damp cloth
1 ]
[
from
[
8 ]
to the
(no steam)
.
3 ]
[
counter-
[
10 ]
into an appropriate
[
8 ]
Publicité
