Publicité
Les langues disponibles
Les langues disponibles
1. Turn the temperature control
clockwise all the way to MIN.
2. Connect the mains plug
appropriate socket-outlet. The control
light
lights up.
[
7 ]
3. Make sure the mains cord is laid out safely.
4. Set the temperature control to the desired
temperature.
As long as the product has not yet reached
the set temperature and is still heating up,
the control light
[
7 ]
temperature has been reached, the control
light remains lit.
5. Once the set temperature has been reached,
you can begin ironing.
˜ Filling the water tank
DANGER! Risk of electric shock!
Always disconnect the mains plug
the socket-outlet before filling the water tank.
m
ATTENTION! Fill the water tank with tap
water or distilled water without any additives.
If your tap water is hard, use distilled water.
Where the water is moderately hard, mix
distilled water and tap water at a ratio of
1:1.
NOTES:
Check the hardness of your household's
o
water with your local water supplier.
The water tank has a filling capacity of
o
approximately 300 ml.
The max mark
[
11 ]
o
filling capacity applies when the product is
set up vertically on the base
Before filling water into the water tank: Set
o
the steam control
4 ]
[
position.
m
IMPORTANT! Use the measuring cup
to fill water into the water tank.
1. Place the product on the base and tip it
forward at approximately 45°.
2. Open the lid of the fill opening
3. Carefully pour water into the water tank. Do
not exceed the max mark.
4. Close the lid of the fill opening
counter-
10 ]
[
with an
8 ]
[
flashes. Once the set
from
[
8 ]
that marks the maximum
.
[
9 ]
to the
(no steam)
12 ]
[
.
3 ]
[
.
Spray function
Prior to ironing, the fabric may be sprayed
o
with water as required. To do so, press the
spray button
.
5 ]
[
Steam burst
You can steam the fabric through the
o
soleplate
as required. To do so, press the
1 ]
[
steam button
.
6 ]
[
NOTES:
The temperature control
o
to generate the steam burst.
You can also use the steam burst in a vertical
o
position.
Steam ironing
You can also set the iron to continuously give
o
off steam.
The temperature control
o
highest level
to produce enough steam.
As long as the product has not yet reached
the set temperature and is still heating up, the
control light
flashes.
[
7 ]
Once the set temperature has been reached,
the control light remains lit.
Set the steam control
o
amount. The steam control has 3 positions:
No
Minimum
steam
steam
NOTE: Continuous steam ironing is only
possible when the iron is held horizontally. If
you hold the iron vertically or set it down, this
interrupts steam operation.
Steam ironing finished: Set the steam
o
control
to the
4 ]
[
should be set to
10 ]
[
should be at the
10 ]
[
to the desired steam
4 ]
[
Maximum
steam
(no steam) position.
GB/IE/NI
11
Publicité
