Ribimex PRSANB030 Manuel D'instructions Et D'utilisation page 5

EN – USER MANUAL
READ THE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR USING THIS
PRODUCT.
THE PRODUCT IS USED FOR LASHING ONLY, BUT NOT FOR LIFTING OR CARRYING
LOADS.
WARNING! PROTECT THE STRAP FROM SHARP EDGES!
CHARACTERISTICS
Reference / article no.
Dimensions
Lashing Capacity (LC)
Material
Reference / article no.
Dimensions
Lashing Capacity (LC)
Material
OPERATION
•
Place the belt around the load and insert one end of the belt
through the slot (I).
•
To tighten the strap, move the ratchet handle (III) back and
forth until the strap is tensioned.
•
Position the handle (III) at the SECURE position (A), the load is
secured.
•
To open the strap, pull up the safety device (II) and fully push
the handle (III) to the OPEN position (C), then the webbing can
be pulled out of the slot (I).
•
WARNING! If there are any cracks or chafing, stop using it.
IMPORTANT
•
The manufacturer's specifications must not be exceeded!
•
If the strap is used incorrectly, there is a risk that the load will not be secured adequately.
INSPECTION
•
Before each use, check the lashing strap for possible damage. If the strap is damaged or the metal parts are
damaged, the lashing strap must be excluded from use immediately.
Imp. par / by: Ribimex S.A. – 56 Route de Paris – FR-77340 Pontault-Combault
Imp. da: Ribimex Italia s.r.l. – Via Igna, 18 – IT-36010 Carrè (Vi)
[v1_2023-09-22]
PRSANB030 / PRSANB025X2 /
711010 711020
25mm x 3m 25mm x 2,5m
250 daN 250 daN
PES PES
PRSANACC060 / PRSANACR090 /
711050 711060
38mm x 6m 50mm x 9m
1000 daN 2000 daN
PES PES
LASHING STRAP
PRSANBC050 / PRSANBCC051 /
711030 711040
25mm x 5m 25mm x 5m
800 daN 400 daN
PES PES
PRSANACR120 / PRSANACR150 /
711070 711080
50mm x 12m 50mm x 15m
2500 daN 2500 daN
PES PES
Page 5 of 14