Würth DKG 1040 Traduction Des Instructions De Service D'origine page 27

Fault
Air leaks on the top side of the
nailer or near to the trigger
Loss of air from the bottom of
the nailer
Nailer does not work or works
slowly
Frequent faults
Maintenance / care
Attention!
Only clean and service the nailer
when it is disconnected from the com-
pressed air supply!
Keep the nailer and the handle dry, clean and
■
free from oil. Always use a clean cloth when
cleaning. Never use brake fluid, petrol or
solvent for cleaning.
The cylinder, O-ring and compression ring are
■
lubricated for the life of the nailer under normal
operating conditions. Further lubrication is not
necessary.
In the unlikely event of a failure or defect,
■
arrange for the nailer to be inspected and
repaired by an authorised customer service
workshop for Würth Compressed Air nailers.
Always quote the item number (see the device
■
type plate) with any enquiries or spare parts
orders.
Troubleshooting
Possible cause
Loose screws
Worn or damaged O-rings or seals Fit repair kit
Loose screws
Worn or damaged O-rings or
anti-shock pads
Insufficient compressed air supply
Insufficient lubrication
Worn or damaged O-rings or
anti-shock pads
Incorrect fasteners
Damaged fasteners
Loose magazine
Dirty magazine
Worn or damaged drive
waste disposal facility. Dispose of all packaging in
an environmentally compatible manner.
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of pur-
chase through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop.
Subject to technical changes without prior notice.
We accept no liability for printing errors.
Remedy
Tighten screws
Tighten screws
Fit repair kit
Ensure adequate air supply
Lubricate nailer
Fit repair kit
Ensure fasteners are the correct
size
Changing the fasteners
Tighten screws, clean magazine
Fit drive maintenance kit
Environmental instructions
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
Warranty
27