Würth DKG 1040 Traduction Des Instructions De Service D'origine page 19

General
Never ignore the safety instructions.
■
When using the tool, bear in mind that the
■
fasteners could be deflected and thus cause
injuries.
Keep your fingers away from the trigger if you
■
are not actually operating the tool and merely
swapping the tool from one working position
to another.
Keep all body parts such as hands and legs,
■
etc. away from the direction of shooting and
ensure that the fastener cannot penetrate
through the workpiece into a body part.
Ensure that you have read and understood the
■
safety instructions before connecting, discon-
necting, loading, operating or servicing the
tool, or changing accessories or working in
the vicinity of the tool. Failure to comply could
result in severe injuries.
During operation, place the nail outlet
■
opening of the tool correctly on the working
surface. If the outlet opening is not correctly
positioned, the fasteners could be ejected
away from the working surface.
Hold the tool firmly in the hand and be pre-
■
pared for the recoil.
Only technically accomplished operators
■
should use the tool.
Do not make any changes to the tool. Mod-
■
ifications can reduce the effectiveness of the
safety precautions and increase the risk for the
operator or bystanders.
When operating with a tool, which is intended
■
for use on hard surfaces such as steel or
concrete, additional contact pressure must
be applied to operate the tool and prevent
slipping.
Do not use any tool that is damaged or not
■
operating correctly. Label the tool as defective
and remove it from the working area to pre-
vent its further use.
Be careful when handling fasteners, especially
■
during loading and unloading because the
fasteners have sharp tips, which could lead to
injuries.
Before use, always check the tool for broken,
■
incorrectly connected or worn parts.
Safety instructions
Avoid an abnormal bodily posture. Only use the
■
tool in a secure work station. Ensure that you can
always maintain a safe standing position and
maintain your balance at all times.
Keep bystanders and children away (if you are
■
working in an area, in which the movement of
people is likely). Clearly mark your working area.
Never point the tool towards yourself or towards
■
other persons. Unintended activations could
cause serious accidents. Ensure that the outlet
opening is not directed towards people when you
are connecting the tool, loading and unloading
fasteners or performing other similar processes.
Do not leave your finger on the trigger when
■
you are lifting the tool, moving it between
working areas and positions or when you are
walking with the tool because this could result in
unintentional triggering. With tools with selective
activation, the tool must always be checked prior
to use to ensure that the correct mode has been
selected.
Only wear gloves that offer appropriate tactile
■
sensitivity and ensure safe control of the trigger
and all adjustment devices.
If not being used, remove the compressed air
■
supply.
You can find detailed information for correct
■
maintenance in the tool maintenance instructions
(maintenance/care). Only qualified personnel
can repair the tool using parts that are supplied
or recommended by Würth or equivalent parts of
the same quality.
Before use, check the tool for the following:
■
• Flawless condition of the tool.
• For which activation system the tool is set and
• No incorrect alignment or jamming of moving
• Compliance with all conditions for the correct
• That before use of the tool all screws and
• Frequently check the operation of the work-
how it functions.
parts.
and safe operation of the tool.
bolts are tightened and have been correctly
attached. Loose or incorrectly attached screws
or bolts would cause accidents and damage
to the tool upon start-up.
piece contact. Do not use the tool if it is not
working correctly, otherwise this could result
in unintentional firing of a fastener. Do not im-
pede the correct functioning of the workpiece
contact.
19