SilverCrest SV 60 A1 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 26

WEAR PROTECTIVE
GLOVES!
Leaked or damaged batteries /
rechargeable batteries can cause
burns on contact with the skin .
Wear suitable protective gloves at
all times if such an event occurs .
In the event of a leakage of
batteries / rechargeable batteries,
immediately remove them from the
product to prevent damage .
Remove batteries / rechargeable
batteries if the product will not be
used for a longer period .
Risk of damage of the
product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (–) on the battery /
rechargeable battery and the
product .
Clean the contacts on the
battery / rechargeable battery
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately .
24 GB/IE
˜ Before use
˜ Unpacking
Remove the packaging . Check if all parts are
complete .
˜ Inserting/Replacing the battery
For first time use, pull out the insulation strip from
the battery compartment 30 .
Open the battery compartment 30 by pulling out
the battery receptacle (located at the back of the
remote control 31 (Fig . H) .
Remove the used battery if present .
Insert a button cell (type CR2025) into the
battery receptacle . The + polarity marking has to
point upwards .
Slide the battery receptacle back into the battery
compartment 30 .
˜ Assembly
Fig. Step
NOTE: The following parts are for
transport only . After unpacking, remove
and discard these parts .
Security tube (located on the shaft of the
main unit 16)
Security plug (located between rear grille
A
2 and blade 4 )
Unscrew the L-shaped bolt 10 . Remove the
washer 9 from the stand post 12 . Place
the stand post 12 on the round base 11 .
Fasten both parts with the washer 9 and the
L-shaped bolt 10 .
Extend the upper pole 14 to its maximum
length (refer to "Height adjustment") . Place
B
the main unit 16 on the upper pole 14 . Fasten
both parts with the locking knob 15 .