Télécharger Imprimer la page

Bose L1 Pro8 Guide Du Propriétaire page 8

Masquer les pouces Voir aussi pour L1 Pro8:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 98
System Setup
Connecting Power
Plug the power cord into the Power Input on the L1 Pro.
1.
2.
Plug the other end of the power cord into a live
electrical outlet.
Note: Do not power on the system until after you've
connected your sources. See Connecting Sources below.
3. Press the Standby Button. The LED will illuminate
white while the system is on.
Note: Press and hold the Standby Button for 10 seconds to
reset the system to factory settings.
AutoOff/Low-power Standby
After four hours of no use, the L1 Pro will enter AutoOff/
Low-power Standby mode to save power. To wake the
system from AutoOff/Low-power Standby mode, press the
Standby Button.
Note: Disable AutoOff/Low-power Standby mode by
pressing and holding all three Channel Parameter Controls for 10 seconds, or via the Settings page in the Bose app. Enable
AutoOff/Low-power Standby mode by repeating this step. Disabling AutoOff/Low-power Standby mode will result in higher
energy usage when the L1 Pro is not in use.
Connecting Sources
Channel 1 & 2 Controls
Channel 1 and 2 are for use with microphones, guitars, keyboards, or other
instruments. The channel inputs are suitable for a wide range of input types
and will have the proper gain staging to minimize noise when the channel
volume is set for the desired output level.
Connect your sound source to the Channel Input with the
1.
appropriate cable.
2.
Apply a ToneMatch preset—to optimize the sound of your microphone or
instrument—by pressing the Channel ToneMatch Button until the LED
for your chosen preset is illuminated. Use MIC for microphones and use
INST for acoustic guitars and other instruments. Use OFF if you do not
want to apply a preset.
Note: Use the Bose app to choose custom presets from the ToneMatch
library. The corresponding LED will illuminate green when a custom
preset is selected.
3. Press the Channel Parameter Control to choose a parameter to modify.
The parameter name will illuminate white while it is selected.
4. Rotate the Channel Parameter Control to adjust the level of the selected
parameter. The parameter LED will indicate the level of the
selected parameter.
Note: While Reverb is selected, press and hold the control for two
seconds to mute the reverb. While reverb is muted, Reverb will flash
white. To unmute reverb, press and hold for two seconds while Reverb is
selected. Reverb mute will reset when the system is powered off.
8 • English
q
w
q
L1 Pro8/Pro16 Portable Line Array System • Owner's Guide
GLOBAL.BOSE.COM
e
INPUT
MIC
w
INST
OFF
VOLUME
e
T T R R EB
EBL L E E
BAS S S S
BA
R R E E V V E E R R B B
VOLUME
r
T T R R EB
EBL L E E
BAS S S S
BA
R R E E V V E E R R B B

Publicité

loading

Ce manuel est également adapté pour:

L1 pro16