Table des Matières
Publicité
Straight Stitch
2
1
3
The straight stitch is used to sew a seam in woven
fabrics and may also be used for gathering, basting,
4
0
sewing in a zipper, pintucks, rolled hems and twin
needle hems.
NOTE: Fine fabrics should have a stitch length be-
tween 1.5 and 2.5, medium fabrics between 2.0 and
3.0 and heavier fabrics between 3.0 and 4.0.
4
3
Starting To Sew
Raise the presser foot and position the fabric next to
a seam allowance line on the needle plate. Lower
the needle to the point where sewing is to begin.
Pull the threads under the foot towards the back and
lower the presser foot. Press the foot control. Gently
guide the fabric along the seam allowance line letting
the fabric feed naturally.
Finishing Off a Seam
To fasten the threads at the end of a seam, press
and hold the reverse stitch lever while sewing.
Raise the presser foot. Use the flywheel to bring the
needle to its highest position before moving the fab-
ric. Remove the fabric; pull the threads up and into
thread cutter to cut them the proper length to start
the next seam.
Changing Sewing Direction
Begin sewing and stop when you reach the point
where you want to turn the fabric. Using the flywheel,
bring the needle down into the fabric.
Raise the presser foot.
Pivot the fabric around the needle to change the
sewing direction. Lower the presser foot and con-
tinue sewing.
36
Publicité
Table des Matières
