GYS POT PTI GENIUS Mode D'emploi page 54

ASSEMBLY AND REPLACEMENT OF THE ARMS ON THE G CLAMP
The warranty does not cover anomalies and damages due to improper assembly of the G-clamp arms.
IMPORTANT :
- do not use copper grease on the arms.
- keep the arm base and arm support on the clamp clean to ensure a good flow of current between the parts in contact.
- If not used for a long time, always store the machine with an arm mounted on the clamp to avoid dust on the arm support.
Procedure for changing the arms :
During the replacement of the arms on the clamp, the cooling circuit pump must be switched off. To do this, place yourself in the «Clamp Setting»
mode on the machine; the red light on the clamp button (FIG 2 -12) indicates that the pump is off. The electrode retracts into the clamp to allow the
arm to be removed.
1
The latch sticks out on the lock side
2
The lever must be in the rear position stop (~120°)
3
The arrows must be aligned
4
Tilt the arm about 15° and remove it from its housing (the pins must slide into the groove)
3
MECHANICAL OVER-OPENING OF THE ARM
To open the arm and gain easier access to the bodywork, activate the over-opening by pressing the clamp button (FIG 2 -10).
1
Press the button (FIG 2 -10)
2
The latch sticks out on the open lock side
3
The lever must be open (~90°) at the stop on the latch.
4
The arrows must not be aligned
Incline the arm.
4
54
BMW C7502655 - GYSPOT PTI GENIUS
2
4
1
3
1
2
2
4
3
1
3
1
4
2
EN