Publicité
Les langues disponibles
Les langues disponibles
To delete the contents of a report, you must
display it on the screen using the button
Identification mode
List of screens used to enter a repair order :
If a repair order has already been created, it cannot be changed or deleted on the machine. To delete it, use the Gyspot software on the PC. The user
can create a maximum of 100 repair orders.
Repair order
Vehicle make
The arrow keys (
field. Press the
52
BMW C7502655 - GYSPOT PTI GENIUS
Then press the
The following message appears on the
.
screen.
If the identification mode is set to «ON», all mandatory fields in the repair order must be entered to
allow the weld to go ahead or the machine will display «identification fault».
To activate and deactivate the identification mode, an SD identification card must be inserted in the
BP card reader instead of the SD card containing the programs.
The settings screen is activated by pressing and holding down the
When the SD card «identification» is inserted and «identification ON» is selected, the supervision
screen is displayed.
This screen is used to make the fields «registration, vehicle make, vehicle model, vehicle model,
chassis number» mandatory fields when entering the repair order.
To exit the screen, press the
containing the programs back into the machine card reader.
User identification
or
) are used to change the letters or numbers. The keys - and + are used to move the cursor inside the
button briefly to clear the field. The
button.
When the triangle is displayed, a second press on
the
displayed.
The triangle disappears from the screen automati-
cally after 3 seconds.
button for 2 seconds. Then, it is necessary to put the SD card
Vehicle model
button allows you to scroll through the fields for editing or reading.
EN
button erases the content of the report
button for 2 seconds.
Registration (optional)
Chassis number (optional)
Publicité
