Publicité
Les langues disponibles
Les langues disponibles
Switching off
Holding the button TARE
will off the product. If no movement is detected on
the weighing surface
1
is pressed, the product will automatically switch off.
Troubleshooting
= Fault
= Cause
= Solution
= The display shows one of the following symbols
when you switch on the product:
• "T"; or
• "-" symbol; or
• the numerical display
= The product has memory features of the previous
weight before switching off the product and affects
the calibration point during activation.
= 1. Remove any load from the weighing surface
if any.
2. Set the product on a solid, level and flat surface.
3. Reset the product by holding the button UNIT
for approx. 3 seconds.
4. The product is re-calibrated and the whole
LC display
will be shown for 2‒3 seconds.
2
5. The numerical display
with the default unit.
6. You could place the item you wish to weigh
onto the product.
for approx. 3 seconds
3
for 3 minutes and no button
showing any weight
8
will read "0" again
8
=
= The product is overloaded.
= 1. Remove the overload.
2. Reset the product by holding the button
UNIT
4
3. The product is re-calibrated and the whole
LC display
4. The numerical display
with the default unit.
5. You could place the item you wish to weigh
onto the product.
Note: If
is shown again, it means the overload is
greater than the max. measuring range. Remove the
overload.
,
Note: Be sure never to add more than 5 kg to the
1
weighing surface
damage it.
4
=
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the battery (see section "Replacing the
battery").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disrupted
by radio transmitting equipment in the immediate vicinity.
If the LC display
objects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the batteries
for a short while and then replace them.
for approx. 3 seconds.
will be shown for 2‒3 seconds.
2
will read "0" again
8
. Overloading the product can
1
indicates a problem, move such
2
GB/IE/NI
11
Publicité
