LD Systems AMP 405 Manuel D'utilisation page 6

ATTENTION:
1. Do not install or use the device in the vicinity of radiators, heat accumulators,
furnaces, or other heat sources. Ensure that the device is always installed in such a
way that it can be sufficiently cooled and cannot overheat.
2. Do not place ignition sources such as burning candles near the device.
3. Ventilation openings must not be covered, and fans must not be blocked.
4. Use the original packaging or packaging provided by the manufacturer for transport.
5. Avoid shock or impact to the device.
6. Observe the IP protection class as well as the ambient conditions such as
temperature and humidity according to the specification.
7. Devices can be continuously further developed. In the event of deviating
information on operating conditions, performance, or other device properties
between the user manual and the device labelling, the information provided on
the device always has priority.
8. The device is not suitable for tropical climates or for operation at heights of 2,000 m
above sea level or higher.
CAUTION:
Connecting signal cables can cause significant interference noise.
Make sure that devices connected to the output are muted while making connections.
Otherwise, noise levels may cause damage.
ATTENTION: HIGH-VOLUME AUDIO PRODUCTS!
This device is designed for professional use.
The commercial operation of this device is subject to the applicable national regula-
tions and guidelines for accident prevention.
Hearing damage due to high volume and continuous exposure: use of this product may
generate high sound pressure levels (SPLs) that may cause hearing damage. Avoid
exposure to high volumes.
INSTRUCTIONS FOR INDOOR INSTALLATION EQUIPMENT
1. Devices for installation applications are designed for continuous operation.
2. Devices for indoor installation are not weather-resistant.
3. Surfaces and plastic parts can age even in installation equipment, for instance,
due to UV radiation and temperature fluctuations. This generally does not impair
functionality.
4. With permanently installed devices, the accumulation of impurities such as
dust is to be expected. Always observe the care instructions.
5. Unless explicitly stated otherwise on the device, the devices are intended for instal-
lation heights of less than 5 m.
6