ATTENTION:
1. Do not operate the device if it has been exposed to large temperature fluctuations
(for example, after transport). Moisture and condensation can damage the device.
Switch on the device only when it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains correspond to the values
indicated on the device. If the device has a voltage selector switch, do not turn on
the device until it has been set correctly. Use only suitable mains cables.
3. To disconnect the device from the mains at all poles, it is not sufficient to press the
on/off switch on the device.
4. Make sure that the fuse used corresponds to the type printed on the device.
5. Make sure that appropriate measures have been taken against overvoltage
(for example, lightning strike).
6. Observe the specified maximum output current on devices with Power Out connection.
Ensure that the total current consumption of all connected devices does not exceed
the specified value.
7. Replace plug-in mains cables only with original cables.
DANGER:
1. Danger of suffocation/choking! Plastic bags and small parts must be kept out of
reach of persons (including children) with reduced physical, sensory, or mental
capabilities.
2. Danger caused by falling device! Make sure that the device is securely installed
and cannot fall down. Only use suitable stands or mounts (particularly for fixed
installations). Ensure that accessories are properly installed and secured.
Ensure that applicable safety regulations are observed.
WARNING:
1. Use the device in the prescribed manner only.
2. Operate the device only with the accessories recommended and intended by the
manufacturer.
3. During installation, observe the safety regulations applicable in your country.
4. After connecting the device, check all cable routes to avoid damage or accidents,
for example, due to tripping hazards.
5. Always observe the specified minimum distance to normally flammable materials!
Unless explicitly stated, the minimum distance is 0.3 m.
CAUTION:
1. Moving components such as mounting brackets or other movable components may
become jammed.
2. Devices with motor-driven components may result in injury from the movement of
the device. Sudden movement of the device can cause shock reactions.
5