Publicité
Les langues disponibles
Les langues disponibles
To remove the Surfer Bather from the bath
•
Drain the bath water.
•
To aid removal from the bath, the platform should
be separated from the scissor lift. Partially elevate
the Surfer Bather and pull the locking catch levers
fully out (see fig. 5) to unlock the platform from the
scissor lift. Unclip the platform from the scissor lift
(1 fig. 8). Swivel the platform as indicated (2 fig. 8) to
disengage the bars from the slots on the underside
of the platform.
NOTE: The locking catches must be released before
attempting to separate the platform from the scissors.
•
Lift the rim on each of the two large suction cups
on the base board to release the suction between
suction cup and bath (A fig.9) and remove the scissor
assembly from the bath.
•
The four small suction cups on the base board
(B fig.9) will release their suction as the scissor
assembly is lifted from the bath.
NOTE: Never attempt to remove the Surfer Bather from
the bath without first breaking the suction under each
of the two large base board suction cups or damage will
result.
Routine Cleaning
After use, fully inflate and rinse with clear water to remove soaps and impurities. The Surfer Bather can be cleaned
with a proprietary liquid cleaner or disinfectant; wiped dry or left to air dry - Do not dry using hot air. Remove the
foam inserts and launder the backrest netting and straps in accordance with the care label instructions. The foam
inserts should be hand washed in warm water with detergent and thoroughly rinsed in clean water to remove all soap
deposits. Gently squeeze the foam to remove surplus water and leave to air dry.
The Platform Pad should be hand washed only, in warm water using a mild detergent, thoroughly rinsed in clean
water and then air dried (The surface of the pad can be wiped to remove excess water - do not wring or put in spin
drier) - Do not dry using hot air.
Disinfecting
All components should be pre-cleaned (with the bellows fully inflated) by washing with detergent and water and then
disinfected using a proprietary sterilizing solution or any antibacterial cleaner. Rinse after disinfecting - Do not dry
using hot air.
Maintenance
Winncare recommends that your Surfer Bather is inspected annually by either your supplier or other suitably qualified
person. If required, Winncare can provide the above inspection within an annual service contract (UK only). Please
contact our Customer Service Department for further details on Freephone 0800 2800 485.
SURFER BATHER
ENGLISH
8
2
8
A
9
1
B
Publicité
