Publicité
Les langues disponibles
Les langues disponibles
Unlocked
Locked
B
MIN
'Up'
'Down'
5
A
GAP
6
7
PLEASE NOTE: The platform flaps may become stiff
following long periods of storage, this can be cured by
fully opening and then closing each flap, repeating as
necessary until each flap moves easily.
Fitting the Surfer Bather in the bath
WARNING: Ensure that the locking catches are in the
locked position before placing the Surfer Bather in the
bath (fig. 5).
•
Place the deflated Surfer Bather in the bath so that
the rear of the platform is as close to the non-tap
end of the bath as it will go without resting on the
curve of the bath (A fig. 6). Press down on the
Surfer Bather to secure the base board suction
cups firmly to the bath.
•
Fully inflate the bellows and check that the narrow
end of the platform has adequate clearance,
between it and any overhanging taps (B fig. 6).
WARNING: Always ensure that the suction cups are
correctly positioned and are adhering to the bath before
use.
To raise and lower the Surfer Bather
WARNINGS: Ensure that the child's limbs are well within
the platform area before raising or lowering the Surfer
Bather.
NEVER leave a child unattended whilst they are on the
Surfer Bather.
•
To raise the Surfer Bather, press 'up' on the Airflo
hand control (fig. 7).
•
To stop at any point, release the 'up' button.
To lower the Surfer Bather, press 'down'. NOTE: If
•
the Surfer Bather platform rises after reaching the
bottom of the bath, press the down button again
and keep it held until the remaining air is expelled
from the bellows.
SURFER BATHER
ENGLISH
7
Publicité
