Insert The Batteries - TFA 35.1159 Mode D'emploi

TFA_No. 35.1159_Anleit_03_21 21.03.2021
WEATHER BOY – Wireless weather station
• The outdoor transmitter is splash proof, but not watertight. When placed outdoors, choose a shady and dry place for the
transmitter.
5. Elements
5.1 Base station (Receiver)
A: LCD display (Fig. 1):
A 1: DCF reception symbol
A 3: Weather forecast with symbols and "Weather Boy"
A 5: Battery symbol for the base station
A 7: Indoor temperature
A 9: Maximum and minimum values
A 11: Outdoor temperature
A 13: Channel number and reception symbol
A 15: Time of sun rising/sun setting/day length
A 17: Symbol of sun rising/sun setting/day length
A 19: Day of the week
A 21: Snooze symbol
B: Buttons (Fig. 2):
B 1: SET button
B 3: – /WAVE button
B 5: sensor button
C: Housing (Fig. 2):
C 1: Battery compartment
24
18:19 Uhr Seite 13
A 2: Time (DCF)
A 4: Atmospheric pressure trend
A 6: Comfort level indicator of indoor climate
A 8: Indoor humidity
A 10: Battery symbol for outdoor transmitter
A 12: Circle symbol for the alternating channel
A 14: City code
A 16: Moon phase
A 18: Date/alarm time/seconds
A 20: Alarm symbol
A 22: Symbol Daylight Saving Time (DST)
B 2: +/CH button
B 4: MEM button
C 2: Stand
WEATHER BOY – Wireless weather station
5.2 Transmitter (Fig. 3):
D 1: Transmission indication LED
D 3: 1/2/3 switch for channel selection
D 5: RESET button
6. Getting started

6.1 Insert the batteries

• Remove the protective film from the base station display.
• Open the battery compartments of the transmitter and receiver and place both instruments on a desk with a distance of
approximately 1.5 meter from each other. Avoid being close to possible sources of interference such as electronic devices
and radio equipment.
• Insert at first two new batteries 1,5 V AA in the battery compartment of the base station and then two new batteries 1,5 V
AA in the battery compartment of the outdoor transmitter. Make sure the polarities are correct.
• The device will alert you with a beep and all LCD segments will be displayed for a short moment. The LED transmission
indicator on the transmitter flashes red.
• After a successful installation close the battery compartments carefully.
6.2 Reception of outdoor temperature
• After the batteries are inserted, the outdoor values will be transmitted to the base station. The reception symbol for the
transmitter flashes.
• As soon as the base station receives the outdoor temperature, the value is permanently shown.
• If the reception of the outdoor values fails within three minutes, "- -" remains on the display. Check the batteries and try it
again. Check if there is any source of interference.
• You can also start the outdoor transmitter search manually later on (for example when the outdoor transmitter is lost or the
batteries are changed).
D 2: Battery compartment
D 4: Wall mounting hole
25