Scan Function - Futech GYRO RED Mode D'emploi

Lead point
•
Thanks to the lead point (7) on the top and at the bottom, this device can also
be used to bring a plumb lead point of the floor to the ceiling, or the other way
round.
• Mark the starting point, place the laser beam exactly on this and sign the op-
posite lead point accordingly.
Corners of 90°
•
In the vertical position it's possible to beam corners of 90°
• To be able to do this you need to place the device as precise as possible above
the starting point. (the place where the corner of 90° is made)
• Bring the laser beam with the help of the keys (14) X-AS to your mark. The lead
point (7) indicates the corner of 90°

Scan function

•
The scan function allows to limit the laser beam to an angle (instead of a
complete circle) so you can find the beam more easily. This is certainly recom-
mended in places with high light intensity and or for long distances.
• The scan function is turned on with key (11) ,to widen the scan field you need
to press (11) again. There are 4 different widths available on the instrument.
• For the positioning of the scan function to the left or right you need to use keys
(10)
Slopes
•
The instruments shows a 100% horizontal laser beam by default. When needed,
it is also capable to project a beam with a slope.
•
To set up the slopes you need to do a few steps in the right order.
• Make sure that the laser is placed in the right axis-direction, this has to be
parallel with the slope line you want to make. For example for the draining of a
sewer pipe, you place the device in parallel with the direction of the pipe. Use
the axis-direction on the top of the device for this (1) X or Y – axis
• Turn the device on (8) and let the device level.
•
Turn the manual mode on (13) (1x for X-axis, 2x for Y-axis) and choose a dis-
tance in the direction of the slope that needs to be set up. For example 10m.
GYRO RED / GYRO GREEN
EN
45