Slope Function - Futech MULTICROSS 8 Mode D'emploi

Masquer les pouces Voir aussi pour MULTICROSS 8:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Slope function

EN
To activate the slope function, you must position the device, paralell to the slope plane.
You can do this by using the plumb point (7) and a laserline.
Turn the unit on, and wait untill it is levelled.
To activate the slope function, press the on/off switch for a few seconds untill the
middle LED turns red.
5sec
BEWARE: Only the horizontal, and the front vertical laserline are visible.
BEWARE: If you want to use a laser receiver, activate this function by pressing the
outdoor button first. You have to do this before setting a slope.
BEWARE: If you want to set a 90° angle, please do this before activating the slope
function.
When the slope function (manual mode) is activated, the LED's next to "H" and "V"
turns green. These LED'S indicate the first axe. (X-axe)
To adjust the slope, hold button "H" or "V". Keep doing this untill the correct slope is
obtained.
46
Multicross 8 High Precision Super Vision
V
H
4
Horizontal
4
Vertical
On/O
Outdoor
Multicross 8 HPSV
041.08
H
V
4
Horizontal
4
Vertical
On/O
Outdoor
Multicross 8 HPSV
041.08
H
4
Horizontal
4
Vertical
On/O
Outdoor
Multicross 8 HPSV
X
041.08
V
www.laseto.be
X

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

041.08.lt

Table des Matières